Properly formatted LUNS not showing up

huntson's picture

I have some raid units that are being run through an Atto SCSI->Fibre bridge. This unit went down so I shut down my SAN while the unit was getting repaired. Now that I have put everything back the LUNS that were showing up from the fibre bridge are not showing up anymore in Xsan Admin and thus the volumes are not able to mount. Interestingly the disks show up in Disk Utility and as Xsan formatted. Any ideas?

MDCS: 10.8.3

xsanguy's picture

What's the output of "sudo cvlabel -l"